...
| Info |
|---|
This issue occurs when the coin tubes are to low to dispense change or have been reset but a power issue or accidental reset of the tubes. If this happens, change will need to be emptied/dispensed and reloaded. |
Dispense Change
Open the Kiosk door with the key and look for the following control panel in the upper right hand corner as well as the screen in the back of the unit.
Press and hold the center button on the control panel until it reads Entering Service Modes and press the right button.
...
Press the upper and lower buttons to navigate to Meters. Then press the right button
Press the up and down buttons again and find Dispense. Then press the right button.
Use the up and down buttons to see if there are coins registering in the tubes. Beside Dispense is the type of change and Coin Quantity is how many coins it registers. If the counts are low you will need to load change (please select load change from the upper menu).
If you see a low number but money in the tubes, you will need to dispensed the coins by holding down the center button until all the coins have been dispensed. If the coin tubes and counts look correct skip the next step and call Marmot.
...