This article will show you how to reseat both the RAM and the M2 drive for Precision desktops. The specific model used in making the instructions was a Precision 3450. This is an involved procedure, requiring many steps to describe it.
...
| Note |
|---|
It is highly recommended to disconnect all cables form the computer before starting. Be sure to note which USB port directly-connected printers are plugged into, as there will be problems with them if they get later reconnected to a different port. You will need a small screwdriver near the end of this. |
\uD83D\uDCD8 Instructions
...
Pictures 34 & 35 show the side of the computer laid into the slots in the frame, prior to sliding toward the front and locking into place. There needs to be about a 1/2 to 3/4-inch gap between the front edge of the side and the face of the computer for the tabs in the side to line up with their corresponding slots in the frame. Once the side slides closed & locks, you’re all done, and can reconnect the computer. Time to reconnect all the cables, then test and see if it works!
...